Human Prostate Specific Acid Phosphatase (PSAP) Antibody
(tested or 100% immunogen sequence identity)
Protein A/G purified
Also available Ready-to-Use
- IHC (1:100 - 1:200)
- ELISA (1:100 - 1:200)
See our complete line of Immunohistochemistry Reagents
including antigen retrieval solutions, blocking agents
ABC Detection Kits and polymers, biotinylated secondary antibodies, substrates and more.
Recombinant human PSAP.
Dilute antibody to its recommended working dilution using the same buffer defined in the Presentation. Manual Use: 1. Pretreatment: Perform heat-induced epitope retrieval (HIER) at pH 9 for 10 to 30 minutes. 2. Peroxide Block: Block in peroxidase blocking solution for 5 minutes at room temperature. (Not required if using Alkaline Phosphatase System.) 3. Primary Antibody: Dilute antibody at 1:100-1:200 before applying. Incubate antibody for 10 to 30 minutes at room temperature. 4. Secondary Antibody: Incubate for 20 to 30 minutes at room temperature. 5. Substrate Development: Incubate DAB or Fast Red for 5 to 10 minutes at room temperature. 6. Counterstain: Counterstain with hematoxylin for 0.5 to 5 minutes, depending on the hematoxylin used. Rinse with distilled water and blueing solution for 30 seconds. 7. Dehydrate and apply coverslip.
Tris, pH 7.3-7.7, 1% BSA, <0.1% Sodium Azide
Store at 2°C to 8°C. Do not freeze.
For research use only. Intended for use by laboratory professionals.
This antibody carries the LSBio 100% Guarantee.